Toe jacks provide a low load-contact point for the lifting arrangements specified by the manufacturer. Browse BVA and Simplex models with different starting clearances and travel.
Toe capacity may differ from head capacity
Confirm the permitted load at the contact point you will actually use. A nominal jack rating is not sufficient evidence of toe capacity. Check toe dimensions, minimum height, lift travel and the required base support.
Review the operating and load-support instructions for the exact model. When lifting through a top saddle is appropriate, compare bottle jacks. For moving a positioned load, see load skates.
Measure the toe engagement as well as the gap
A toe can reach a low contact point, but it still needs the engagement and load-contact conditions specified for the jack. Measure the insertion gap, available bearing surface and nearby obstructions. Check whether the jack's body and handle can remain in a suitable position as the load rises.
For a machinery installer, a useful sketch shows the machine foot, toe contact, floor and body position at the beginning and end of the lift. That reveals access problems that a tonnage-and-stroke specification can miss.
| Toe-jack detail | Selection consequence |
|---|---|
| Toe load rating | Must cover the actual load at that contact point |
| Head load rating | Applies only to the specified top contact arrangement |
| Minimum toe height | Determines initial access |
| Toe engagement and travel | Determine how the load can be contacted and moved |
Examples for checking model differences
TJH10A and TJH109 give buyers two Simplex toe-jack listings to examine. Confirm the contact-point ratings, travel and installed dimensions individually rather than treating the shared family designation as an identical geometry.
Can I use the top-head capacity when lifting on the toe?
Only use the capacity stated for the contact point in use. Where separate toe and head ratings are published, they are separate limits.
Does the toe work on any machine edge?
No. The machine's lifting point and the jack's required contact must both be suitable. A thin flange or unsupported sheet-metal edge is not automatically a lifting point.
How do I move the machine after lifting it?
Plan an appropriate supported transfer onto load skates or other transport equipment. The jack selection alone does not define that transfer or route.
